Oem: 11061-1271.
Ensuring the integrity of the ignition compartment is fundamental for every off-road rider. The gasket generator marketed by Motocross Marketing is designed to offer an impenetrable barrier against mud, debris, and moisture. This ignition cover seal is the specific replacement for those seeking maximum reliability during track sessions or long enduro rides, where thermal stress and frequent washing put every component to the test.
Why Replace the Gasket at Every Service?
Each time the cover is removed to inspect the generator or for interventions on the electrical system, the original seal undergoes permanent plastic deformation. Even if it visually appears to be in good condition, the material structure has lost its ability to adapt to the microscopic imperfections of the metal surfaces. Reusing an old component drastically increases the risk of infiltration. The entry of water into the magneto cover can cause premature oxidation, pick-up malfunctions and, in the most severe cases, total damage to the stator.
Technical Specifications and Build Quality
● Materials: Composed of high-quality cellulose fiber and synthetic resins, designed to withstand high operating temperatures without hardening or cracking.
● Manufacturing: Made via precision die-cutting, which faithfully follows the profile of the original component (OEM) for mounting without any modification.
● Technology: Non-stick surface treatments to facilitate future removal without leaving stubborn residue on the engine case.
● Finish: Regular surface that guarantees uniform distribution of the screw closing pressure.
Advantages Over the Original Product
Choosing a Motocross Marketing flywheel insulator means relying on a product that respects the manufacturer’s technical specifications, but with a smaller investment. The quality of the materials is comparable, if not superior in terms of mechanical resistance, guaranteeing the same longevity as the original equipment part.
Mounting Instructions
Installation must be carried out by specialized personnel, following the motorcycle manufacturer’s instructions. For an optimal result, we recommend:
1. Thoroughly clean the contact surfaces with a specific degreaser or brake cleaner.
2. Check that there are no deep scratches on the case mating surfaces.
3. Position the gasket dry (unless otherwise indicated in the workshop manual).
4. Tighten the cover screws following the criss-cross pattern with the indicated tightening torque (Nm).
Motorcycle Compatibility
Always check the correspondence with your specific model in the motorcycle compatibility of this page.
FAQ – gasket generator
Can I reuse the old gasket if it still feels soft?
No, it is strongly discouraged. Once compressed by the screws, the gasket loses the ability to seal hermetically again, risking oil leaks or water infiltration.
Is it necessary to apply red paste or silicone sealant?
Generally no. If the case surfaces are intact and clean, the Motocross Marketing gasket ensures a perfect dry seal.
Is the product resistant to gasoline and solvents?
Yes, the material is designed to resist chemical agents found in engines and detergents used for motorcycle washing.
What happens if water gets inside the generator cover?
Moisture can cause immediate short circuits or slow oxidation of the stator, leading to the failure of the electrical system and the inability to start the bike.
Are assembly instructions included?
The package contains the gasket ready for use; for tightening specifications it is necessary to consult the technical manual of your motorcycle.
The Crosshop staff remains at your disposal for any further clarification, do not hesitate to contact us.